Clickless Mouse 2.2

Clickless Mouse makes using a computer easier for people with repetitive strain injury, carpal tunnel syndrome, some motor disabilities and other health problems.

This application allows using a mouse without clicking - by moving it only.

By reacting to user mouse movements this program simulates left/right mouse button click, double left mouse button click and left/right mouse button holding.

Clickless Mouse can be used with a virtual keyboard to type by moving a mouse (e.g. Free Virtual Keyboard).

By using Clickless Mouse with a virtual keyboard a user can fully control a computer by moving a mouse.

When you want to click/hold a mouse button: stop moving the mouse, wait for the squares to appear and move the mouse cursor to the chosen square:

- Top center square = double left mouse button click

- Top left square = left mouse button click

- Top right square = right mouse button click

- Left square = left mouse button holding on/off

- Right square = right mouse button holding on/off

When the mouse cursor is located inside a square long enough (depending on cursor time in square to register click setting), it automatically moves back to the previous position to simulate an action based on the square that was previously entered.

If the mouse cursor is too close to the top edge of the screen, squares for LMB click, RMB click and LMB double click are shown below the mouse cursor.

If the mouse cursor is too close to the left/right edge of the screen all squares size decrease so at least 25% of a square is visible. By default decreased square size cannot be lower than 60% of the normal size. Squares size don't decrease if the mouse cursor is so close to the edge of the screen that smallest size isn't enough to show a square.

The squares that aren't needed can be disabled.